14. How to Use the Front Panel — Structure of Each Mode

Abstract

The led front panel of the Panasonic A6 servo motor driver will display the running status of the motor and the alarm code if there's an alarm occurred during the running of the system. It's also the interface of Panasonic A6 servo motor to the operator in parameter setting. Here in this chapter you'll have an outlined guide of each mode of the Panasonic A6 series motor driver.

Use each button on the touch panel to select the structure and switch the mode.

Note → You can change the flashing decimal point with <, then shift the digit for daga change "."
Caution → On power-up, the monitor mode executed is displayed according to the setup of Pr5.28 LED initial status.

As for which injection molding machine is a better choice for your IML project, it'll depends on your budget and requirement about the parts. As we know both P250E and P280K3 are excellent high speed injection molding machine designed for the injection production of thin wall containers with high injection speed for the fast injection of thin wall containers. They're no dobt excellent injection molding machine for your IML project. But, how to make a decision between?

Both P250E and P250K3 has similar injection speed (300/500 mm/s optional for P250E and 320mm/s for P250K3) but P250E is an all electric injection molding machine while P250K3 is a high speed hydraulic injection molding machine. Of course an all electric injection molding machine is a better choice for food container IML production, but, the cost of it would be much higher than P250K3. So, if your budget is sufficient, P250E, if not, P250K3 would be the right one for you.

The IML robot for YIZUMI P250K3/P250E would be SWITEK IML Robot SW833. In K2019 SWITEK IML robot SW833 work with P250E in demo of 4 cavities cups at the cycle time of 2.1s, this combination is one of the best IML solution for small size containers IML production.